Minuetta       as in Klang + Ton 5/2005

Minuetta aus Klang+Ton 5/2005 Minuetta is a bass reflex combination consisting of the following 4 versions:
- Minuetta Top, a 2 way bass reflex with Eton ER4 (AMT) and Eton 5-880/25 hex
- Minuetta Top Light, a 2 way bass reflex with Eton 19 SD1 (dome) and Eton 5-880/25 hex
- Minuetta, a 3 way bass reflex with Eton ER4 (AMT), 5-880/25 hex and 8-800/37 hex
- Minuetta Light, a 3 way bass reflex with Eton 19 SD1 (dome), 5-880/25 hex and 8-800/37 hex

This enables you to choose from two Top versions, either containing the airy Air Motion Transformer ER4 or a dome tweeter for high frequencies. It also up to you whether you prefer to use the small shelf speaker on its own or in conjunction with an additional Sub part (containing the Eton 8-800/37 hex).

Technical data for Top:
- impedance: 8 Ohm
- SPL (2.83V/1m): 83 dB
- frequency range (-8dB): 50-25 000 Hz
- crossover frequency: 2200 Hz
- size (HxWxD): 32 x 19.8 x 26 cm
- cabinet type: bass reflex

Technical data for combination:
- impedance: 8 Ohm
- SPL (2.83V/1m): 88 dB
- frequency range (-8dB): 40-25 000 Hz
- crossover frequency: 500/2300 Hz
- size Top (HxWxD): see above
-     Sub (HxWxD): 73.8 x 26.8 x 31.8 cm
- cabinet type: bass reflex

The first two versions come with a small bass reflex cabinet. The last two versions contain an additional subwoofer; then the Top part is a closed cabinet for improved impulse response.

Short excerpt of Klang + Ton's review in issue 5/2005:
..."We asked ourselves where there was still room for improvement when we first listened to the Minuetta Light. Our initial listening test using a valve amp showed a slightly too rich sound. We, therefore, exchanged it for a mid prized transistor amp. Initially we had missed the liveliness that the ER4 had presented us with. But soon after, the floorstanding speaker gained ground due to a bigger bass foundation. Now, even large orchestral works showed up deep double bass, bass drums had more oomph and at higher volumes the Minuetta Light performed with considerable more authority than the midgets before. After exchanging the top parts for units with the ER4 we had come close to the Duetta's musical ability and clarity. Some songs showed that the smaller midrange driver scored a few points, some even said quite a few, since the smaller moving mass resulted in a more detailed presentation in the upper midrange. However, thanks to a more balanced presentation Queen Duetta continues to sit enthroned."
 

Our kit versions contain:

Minuetta Top
with:
Minuetta Top Light
with:
Minuetta
with:
Minuetta Light
with:
- Eton ER4
- 5-880/25 hex
- Eton 19 SD1
- 5-880/25 hex
- Eton ER4
- 5-880/25 hex
- 8-800/37 hex
- Eton 19 SD1
- 5-880/25 hex
- 8-800/37 hex
The crossover components, to be mounted on wood.
the coils: ..........................................................................................................
- 1.8 mH Tritec coil with ferrum core
- 0.39 mH air core/0.7 mm
- 1.8 mH HQ58
- 0.39 mH air core/0.7 mm
- 5.6 mH coil DR56
- 1.2 mH coil DR56
- 0.39 mH air core/0.7 mm
- 5.6 mH HQ58
- 1.2 mH air core/1.4 mm
- 0.39 mH air core/0.7 mm
the capacitors: ................................................................................................
- 8.2 uF MKP/400V
- 3.9 uF Audyn CAP
- 8.2 uF MKP/400V
- 5.6 uF Audyn CAP
- 47 uF MKP/400V
- 47 uF MKP/400V
- 1x 15 uF MKP/400V
- 1x 8.2 uF Audyn CAP
- 47 uF ELCO un-etched
- 47 uF MKP/400V
- 1x 15 uF MKP/400V
- 1x 4.7 uF Audyn CAP
the resistors: .....................................................................................................
- 4.7 Ohm MOX4
- 5.6 Ohm MOX4
- 4.7 Ohm MOX4
- 3.3 Ohm MOX4
- 6.8 Ohm MOX4
- 3x 1.5 Ohm MOX4 - 2x 1.5 Ohm MOX4
additional components supplied: .............................................................................
Damping material polyester fleece for the bass reflex Top: 1/2 Pack polyester fleece
Damping material for closed Top: 3/4 pack (=1.5 mats)
Damping material for subwoofer: 2 1/4 pack (bass reflex port remains uncovered).
Screws: 14 PAN screws for Top,
8 Allen screws 4x25 and 4 PAN screws for Sub
Terminals: 1 terminal with 2 gold plated brass binding posts for Top
1 bi-wiring terminal with 4 gold plated brass binding posts for Sub
Foam sealing tape
Cable: 1.5 metre silver plated cable 2x2.5 mm2 for Top
1.5 Meter silver plated cable 2x2.5 mm2 for Sub
Building instruction

Price per kit (1 x Top or combination Top/Sub without cabinet): ..............................................

Minuetta Top Minuetta Top Light Minuetta Minuetta Light
- not available EUR 199,00 EUR 626,00 EUR 405,00

Please note: you may exchange versions as you like; we'll credit the full price.

High-end versions and impedance correction for valve amps

Are you looking for high-end versions? We'll gladly help you to find the appropriate components.
Or, are you looking for components to correct the impedance to connect a valve amp?
Or, do you want us to supply an universal PCB for your kit?

We are looking forward to hearing from you!
E-mail: info@lautsprechershop.de

Home   K+T Overview